Epson WorkForce AL-MX200DNF

No
*
Does not initialize the wired network data stored in NVM.
*
Factory default menu setting
PS Data Format
Purpose:
To set the PS data communications protocol. To make any changes effective, turn off the printer and
then turn it back on.
Values:
Auto
*
Sets the PS data communications protocol automatically.
Standard
Sets the PS data communications protocol to Standard.
BCP
Sets the PS data communications protocol to BCP.
TBCP
Sets the PS data communications protocol to TBCP.
*
Factory default menu setting
Fax Settings
Use the Fax Settings menu to configure the basic fax settings.
Ans Select
Purpose:
To specify the default fax receiving mode.
Values:
TEL Mode
The printer does not automatically receive faxes. To receive an incoming fax,
you need to pick up the handset of the connected external telephone and press
the 2-digit code.
FAX Mode
*
The printer automatically receives faxes.
TEL/FAX Mode
When the printer receives an incoming fax, the external telephone rings for the
period of time specified for Auto Ans. TEL/FAX, and then the printer
automatically receives a fax. If an incoming call is not a fax, the printer beeps
from the internal speaker indicating that the call is a telephone call.
Ans/FAX Mode
The printer shares the telephone line with an answering machine and monitors
the line for a fax tone. It will pick up an incoming call if it hears a fax tone. This
option is not available in regions where a serial phone system is employed.
AL-MX200 Series User’s Guide
Using the Operator Panel Menus and Keypad 282