Epson WorkForce AL-MX200DNF

2. Select Admin Menu and then press the button.
3. Select Maintenance and then press the
button.
4. Select Non Genuine Toner and then press the
button.
5. Select Toner and then press the
button.
6. Select On and then press the
button.
7. Press the
button until the top page is displayed.
The printer switches to the Non Genuine Toner mode.
Using the Printer Setting Utility (Windows Only)
The following procedure uses Windows
®
7 as an example.
1. Click Start — All Programs — EPSON — your printer — Printer Setting Utility.
Note:
The window to select a printer appears in this step when multiple print drivers are installed on your
computer. In this case, click the name of the desired printer listed in Printer Name.
The Printer Setting Utility starts.
2. Click the Printer Maintenance tab.
3. Select Non Genuine Toner from the list at the left side of the page.
The Non Genuine Toner page is displayed.
4. Select the check box next to On, and then click the Apply New Settings button.
AL-MX200 Series User’s Guide
Troubleshooting 379