Auger Mark
Problem Action
The printed result has auger mark. The toner cartridge may be low or need to be replaced. Confirm the amount of
toner in the toner cartridge.
1. Check the toner level on the Consumables tab of the Printer Status window of
Status Monitor.
2. Replace the toner cartridge as needed.
Start Clean Developer.
1. Launch the Printer Setting Utility, and click Clean Developer on the Diagnosis
tab.
2. Click the Start button.
Note:
If the problem continues even though you have taken suggested actions described above, contact our local
representative office or authorized dealer.
Wrinkled/Stained Paper
AL-MX200 Series User’s Guide
Troubleshooting 357
To Next Page
Loading...
