Using the PCL print driver
Identifying Print Driver Pre-install Status (for Network Connection Setup)
Before installing print drivers on your computer, print the System Settings page to check the IP
address of your printer.
Using the Operator Panel
Note:
The reports and lists are all printed in English.
1. Press the System button.
2. Select Report / List, and then press the
button.
3. Select System Settings, and then press the
button.
The System Settings page is printed.
4. Find the IP address under Wired Network (AL-MX200DNF) or Wired Network/Wireless
Network (AL-MX200DWF) on the System Settings page.
If the IP address is 0.0.0.0, wait for a few minutes to resolve the IP address automatically, and then
print the System Settings page again.
If the IP address is not resolved automatically, see “Assigning an IP Address (for IPv4 Mode)” on
page 45.
Using the Printer Setting Utility
The following procedure uses Windows 7 as an example.
Note:
The reports and lists are all printed in English.
1. Click Start — All Programs — EPSON — your printer — Printer Setting Utility.
Note:
The window to select a printer appears in this step when multiple print drivers are installed on your
computer. In this case, click the name of the desired printer listed in Printer Name.
AL-MX200 Series User’s Guide
Printer Connection and Software Installation 50
To Next Page
Loading...
