3. Adjust the document resolution to suit your fax needs.
See Also:
❏ “Resolution” on page 227
❏ “Lighten/Darken” on page 228
4. Select OnHook, and then press the
button.
5. Select On, and then press the
button.
6. Enter the fax number of the remote fax machine using the numeric keypad.
7. Start the fax transmission.
❏ If the document is loaded on the ADF, press the
(Start) button.
❏ If the document is loaded on the document glass, press the
(Start) button, select the desired
setting, and then press the
button.
Note:
You can cancel your fax job at any time by pressing the
(Stop) button while the transmission is in
progress.
Confirming Transmissions
When the last page of your document has been sent successfully, the printer beeps and returns to
standby mode.
If something goes wrong while sending your fax, an error message appears on the LCD panel.
If you receive an error message, press the
button to clear the message and try sending the document
again.
You can set your printer to print a confirmation report automatically after each fax transmission.
See Also:
“Printing a Report” on page 262
AL-MX200 Series User’s Guide
Faxing 231
To Next Page
Loading...
