evertz 3025EMC - Page 196

3025EMC Master Control Switching & Channel Branding
Page 182 Revision 3.0.3
associated to it this will
trigger a take with pre-
roll.
pre-roll sources.
Preview Transition
N/A
Preview a WIPE
transition on the PST
Bus only.
Note: Only works for WIPE
transitions.
Multi Transition Take
Not Supported
Multi Transition Take
Preroll
Not Supported
A/B Mode Current
State
N/A
Displays the current
internal upstream
switch mode, A/B or
B/A.
N/A
Transition Start Hold
N/A
While this key is held
ON this will stop any
pending transition from
starting until the key is
released.
N/A
Keyer 1 Level
N/A
Puts the selected
keyer on the PST Bus
OR makes an on-air
keyer transitional (go
off-
air with next
transition).
N/A
Keyer 2 Level
N/A
Puts the selected
keyer on the PST Bus
OR makes an on-air
keyer transitional (go
off-
air with next
transition).
N/A
Keyer 3 Level
N/A
Puts the selected
keyer on the PST Bus
OR makes an on-air
keyer transitional (go
off-
air with next
transition).
N/A
Keyer 4 Level
N/A
Puts the selected
keyer on the PST Bus
OR makes an on-air
keyer transitional (go
off-
air with next
transition).
N/A
Keyer 1 On-Air
N/A
Toggles the on-air
state if the selected
keyer.
N/A
Keyer 2 On-Air
N/A
Toggles the on-air
state if the selected
keyer.
N/A
Keyer 3 On-Air
N/A
Toggles the on-air
state if the selected
keyer.
N/A