evertz 3025EMC - Page 198

3025EMC Master Control Switching & Channel Branding
Page 184 Revision 3.0.3
Keyer Default
Scrolling or specified
keyer.
Set the Clip, Gain &
Transparency settings
for the keyer back to the
default settings specified
in the configuration.
N/A
Logo Selection
Logo number/position
Make internal media
controllable fro
m the
panel.
Note: The media is
ordered alphabetically.
Logo Position Left
N/A
Adjust the X position of
the currently selected
media to the left.
If this button is
configured directly above
a rotary dial then this
button configures the
function of this di
al as
Logo Position Left/Right.
Logo Position Right
N/A
Adjust the X position of
the currently selected
media to the right.
If this button is
configured directly above
a rotary dial then this
button configures the
function of this dial as
Logo Position Left/Right.
Logo Position Up
N/A
Adjust the Y position of
the currently selected
media Up.
If this button is
configured directly above
a rotary dial then this
button configures the
function of this dial as
Logo Position Up/Down.
Logo Position Down
N/A
Adjust the Y position of
the currently selected
media Down.
If this button is
configured directly above
a rotary dial then this
button configures the
function of this dial as
Logo Position Up/Down.
Logo Take
N/A
Fade-in ALL media that
is currently cue’d.
N/A
Logo Channel
Not Supported.
MG Logo Layer
Not Supported
MG Layer Shift
Not Supported
MG Control Keys 1
Select Logo
Select media (using
Logo Selection)
N/A
Cue Logo
Cue current media
N/A
Fade In Logo
Fade In current media
N/A
Fade Out Logo
Fade Out current media
N/A
Fade All Out
Fade Out ALL media
N/A
Current Logo
Displays the name of the
currently selected media
N/A