·10·
Operating manual
CNC 8070
(REF: 1505)
SOFTWARE OPTIONS.
Bear in mind that some of the features described in this manual depend on the software options that are
installed. The information of the following table is informative only; when purchasing the software options,
only the information provided in the ordering handbook is valid.
-BL- model -OL- model
Open system.
Access to the administrator mode.
- - - Option
Editing and simulation environment. - - - Standard
Number of execution channels 1 1 to 4
Number of axes 3 to 7 3 to 28
Number of spindles 1 1 to 4
Number of tool magazines 1 1 to 4
Number of interpolated axes (maximum) 4 28
Limited to 4 interpolated axes - - - Option
IEC 61131 language - - - Option
Non-Fagor digital drive Option Option
Tool radius compensation Option Option
"C" axis Option Option
Dynamic RTCP Option Option
HSSA machining system. Option Option
Drilling ISO cycles for the OL model.
(G80, G81, G82, G83).
- - - Option
Tandem axes - - - Option
Synchronism and cams Option Option
Tangential control Option Option
Volumetric compensation (up to 10 m³). - - - Option
Volumetric compensation (more than 10 m³). - - - Option
PWM (Pulse-Width Modulation). - - - Option
To Next Page
Loading...
