Operating manual
CNC 8070
DDSSETUP
21.
(REF: 1505)
·381·
List of devices connected to the bus.
21.2 List of devices connected to the bus.
This service shows the list of devices connected to the bus. The information shown by this
service depends on the type of bus used, Sercos or Mechatrolink.
The command line is located at the bottom of the window. See "21.9 Command line." on
page 392.
List of drives of a Sercos bus.
List of devices of a Mechatrolink bus.
Horizontal softkey menu.
Saving and loading the parameters of all the servos.
With this service, it is possible to save and load the configuration of all the Sercos drives or
Mechatrolink servos using a single softkey. The CNC saves the parameters of each device
in a different file whose name will be the name of the axis or spindle and the extension lp
(Sercos drives) or mlp (Mechatrolink servos).
If when restoring the data, a writing error occurs at a drive, the CNC will warn about it and
it will give the option to either resume or abort the process. If when restoring the data, the
Sercos. For each drive, the table shows the name of the axis or spindle associated
with it, its identifier within the bus (node number) and a short description
for it (software version, motor ID and the ID of the drive itself).
Mechatrolink. For each device (servo or inverter), the table shows the name of the axis
or spindle associated with it, its identifier within the bus (node number) and
a short description for it (type of device and addressing according to
Mechatrolink specifications).
Softkey. Function.
Save the data of all the drives.
In a Sercos bus, this softkey saves in the CNC the parameters and variables
of all the drives. In a Mechatrolink bus, this softkey saves in the CNC the
parameters of all the servos; it does not save the parameters of the inverters.
Restore the data of all the drives.
In a Sercos bus, this softkey restores the parameters and variables of all the
drives from the files saved in the CNC. The process of restoring the
parameters includes sending the command to save the parameters to flash.
In a Mechatrolink bus, this softkey restores the parameters of all the servos
from the files saved in the CNC; it does not restore the parameters of the
inverters.
To Next Page
Loading...
