·320·
Operating manual
CNC 8070
18.
PLC
(REF: 1505)
"Monitoring" service
18.10.3 Options of the "Monitoring" service (softkeys).
When accessing the "Monitoring" option of the softkey menu, the following options will be
available.
Save set
This softkey is used to save the set of defined resources into a file. When selecting this option,
the CNC displays a window with the list of the files (.MON) currently saved. To save a set
of defined resources:
1 Define the file name at the bottom window. To replace an existing one, select it from the
list.
2 Press [ENTER] to save the program or [ESC] to cancel the selection and close the
program listing.
Load set
This softkey is used to recover the set of resources previously saved into a file. When
selecting this option, the CNC shows a window with the list of available files. To load one of
these files:
1 Define the file name at the bottom window or select it from the list.
2 Press [ENTER] to load the selected file or [ESC] to cancel the operation and close the
program listing.
Binary
This softkey toggles between displaying the register values in decimal and hexadecimal
format or only in binary.
Visibility
This softkey shows or hides certain resource tables.
Add row
This softkey increases the size of the active window (where the cursor is) by adding a row to it.
Remove row
This softkey decreases the size of the active window (where the cursor is) by removing a
row from it.
Data input
This softkey selects the data entry area.
Clear all
Delete all the resources from the tables.
To Next Page
Loading...
