Operating manual
CNC 8070
HD GRAPHIC ENVIRONMENT (LATHE MODEL)
13.
(REF: 1505)
·221·
Configure the graphics (number of windows, colors, etc.).
13.4 Configure the graphics (number of windows, colors, etc.).
This option is used to configure the graphic environment and each window.
Configuration of the windows (properties of each window).
This softkey is used to configure the properties of the active window so each of the four
windows the screen may be divided into, may have different properties. For example, a
window may show only the part to be machined and another one only the machining tool
paths. The screen may be selected with the tab key or with the keys [1] through [4] (depending
on the window to be selected).
Configuration of the sections.
This option is used to defined up to three planes to cut the graphic. The sections are global
to all the defined parts. If there is a section defined in X100, it will cut all the parts that have
that coordinate in their dimensions.
The definition of the sections is global for all the defined windows, but each window may have
different sections active. To view the sections in a window, one must also enable the "view
sections" option in the window properties.
Softkey. Function.
Configuration of the active window (properties of each
window).
Configuration of the sections.
Configuration of the colors for the part and for the tool paths.
General configuration of the graphics.
Cancel the graphics.
Load machine.
Properties. Meaning.
View part. The graphic shows the solid part to be machined.
View tool path. The graphic shows the machining lines.
View machine. Not being used.
View tool colors. The graphic shows the machining of each tool in the color defined in the
color configuration.
View axes. The graphic shows the first three axes of the channel set as origin
channel for the part. These axes make up the coordinate system used
to reference the part and its origin coincides with part zero.
View sections. The graphic enables the sections, those marked as active in the
configuration of the sections.
Enhance part edges. The graphic enhances the edges of the displayed part.
To Next Page
Loading...
