Operating manual
CNC 8070
EDISIMU MODE (EDITING AND SIMULATION)
8.
(REF: 1505)
·149·
Working in the editing window.
8.4.2 Operations with blocks. Cut and paste.
The "Operations with blocks" softkey is used to copy, cut and paste the information of a block
or set of blocks and export this information as an independent program. This option is only
available when there is a text selected in the program or on the clipboard. To select a text
in the program, keep the [SHIFT] key pressed while moving the cursor.
Operations with blocks "Copy"
Copy the selected text onto the clipboard.
Operations with blocks "Cut"
Copy the selected text onto the clipboard and deletes it from the program.
Operations with blocks "Paste"
Paste the contents of the clipboard into the program.
Operations with blocks "Copy to program"
Save the selected texts as an independent program. When selecting this option, the CNC
shows a list of the available programs. To save the text as a program:
1 Select the destination folder.
2 Define the file name at the bottom window. To replace an existing file, select it from the list.
3 Press [ENTER] to save the program or [ESC] to cancel the selection and close the
program listing.
To Next Page
Loading...
