Operating manual
CNC 8070
EDISIMU MODE (EDITING AND SIMULATION)
8.
(REF: 1505)
·141·
Program editing and simulation
8.2.4 Simulation errors
When an error occurs, the CNC will display a window describing the cause of the error. These
errors are displayed in the middle of the screen, regardless of which window is active.
Pressing the [ESC] key closes the windows one by one. Use the [][] keys to see the
various windows without closing them.
There are two types of errors. The top of the window shows the category and it will have a
different color depending on the type of error it shows.
WARNING
It is just a warning, it does not interrupt the simulation of the program.
The warnings programmed with the instruction #WARNINGSTOP interrupt the execution of
the program where the instruction is located. In this case, It's up to the user to either resume
the simulation at this point, [START], or abort the program, [RESET].
ERROR
The errors do not interrupt the simulation of the program.
Although the window displaying them may be closed by pressing [ESC], it does not mean
that the error status has been taken care of; to do that, press the [RESET] icon. The program
can be neither edited nor simulated while the error stays state active.
To Next Page
Loading...
