Operating manual
CNC 8070
PLC
18.
(REF: 1505)
·295·
Editing in C language or mnemonic language.
18.4.1 Softkey "Analyze".
This softkey analyzes the program searching for errors. The errors found will be displayed
in the "Outputs" service window.
18.4.2 Softkey "File".
File "Restore original"
This softkey is used to recover the original file without the changes made since the last time
it was opened. When selecting this option, the CNC requests confirmation of the command.
This option is only available when the "Save always" option is active. See "18.4.6 Softkey
"Customize"." on page 298.
File "Save"
This softkey saves the file that is being edited.
This option is only available when the "Save always" option is not active. See "18.4.6 Softkey
"Customize"." on page 298.
File "Save as"
This softkey saves the file, that is being edited, with a different name. After saving the file,
one keeps editing the new file.
File "Include program"
This softkey is used to import the contents of a file saved at the CNC into the program that
is being edited.
File "Print"
This softkey may be used to print the program in the pre-determined printer.
18.4.3 Softkey "Undo".
This softkey may be used to "undo" the last modifications made. The modifications are
undone one by one starting from the most recent one. The CNC offers the following keyboard
shortcuts to undo and redo the operations.
To close this window and return to the editor, press [ESC]. To return to the editor without
closing the window, press the [NEXT] key.
This softkey is used to recall, save, import or print a file. When selecting this option, the
softkey menu shows the available options. To return to the main menu, press the [BACK] key.
[CTRL]+[Z] Undo the last change.
[CTRL]+[Y] Redo the selected text.
To Next Page
Loading...
