Operating manual
CNC 8070
DIAGNOSIS
22.
(REF: 1505)
·401·
Configuration diagnosis
22.2.3 Hardware diagnosis. Bus CAN, Sercos and Mechatrolink.
When selecting this element of the configuration, the diagnosis window shows the software
identification of the CNC's communications board (version, boot, checksum) and the type
of buses connected to it. Likewise, it monitors the different voltage and temperature alarms.
Sercos bus configuration
• Listing of nodes and drive associated with each one of them.
For each drive, it indicates its software version, type of drive and the motor connected to it.
Can bus configuration
• Resources connected and their status.
• Groups connected and number of nodes that make up each group (detected and active).
Detailed information of the selected group.
• Group resources and their status.
• Information about the nodes that make up the group.
Detailed information of the selected node.
• Software version, boot and checksum of the code.
• Node status.
• Resources of each module.
The symbol next to the node indicates its status and its possible association.
Active.
Active, but in error.
Inactive.
To Next Page
Loading...
