·150·
Operating manual
CNC 8070
8.
EDISIMU MODE (EDITING AND SIMULATION)
(REF: 1505)
Working in the editing window.
8.4.3 Find a line or a text in the program.
The "Operations with blocks" softkey is used to find a line or a text in the program and replace
a text with another one. When selecting this option, the CNC shows a dialog box requesting
the line number or the text to look for. When defining a text search, certain options may also
be defining that allow:
After defining the search options, press [ENTER] to start the search or [ESC] to cancel it.
The text found in the program will be highlighted and the softkey menu will show the following
options:
• "Replace" option, to replace the highlighted text.
• "Replace all" option, to replace the text throughout the whole program.
• "Find next" option, to skip this text and keep on searching.
• "Find previous" option, to look for the text without replacing it.
To end the search, press [ESC].
A Go to a line of the program.
B Replacing the text being searched with another
in the program.
C Ignore uppercase and lowercase.
D Consider the text to find as a whole word.
E Select whether the search starts at the
beginning of the program or at the cursor
position.
F Direction of the search.
To Next Page
Loading...
