·148·
Operating manual
CNC 8070
8.
EDISIMU MODE (EDITING AND SIMULATION)
(REF: 1505)
Working in the editing window.
8.4 Working in the editing window.
8.4.1 Select a program.
The "Open program" softkey is used to select a program in EDISIMU mode and may be a
new program or an existing one. A different program may be edited and executed in each
channel. When selecting this option, the CNC shows a list of the available programs. See
"3.7 File selection window" on page 61.
To select a program from the list:
1 Select the folder that contains the program. If it is a new program, it will be saved in this
folder.
2 Select the program from the list or write its name in the bottom window. To edit a new
program, write the name of the program in the lower window and the CNC will open an
empty program or a predefined template depending on how the editor is configured. See
"8.4.6 Customizing the editor." on page 153.
3 Press [ENTER] to accept the selection and open the program or [ESC] to cancel it and
close the program listing.
To Next Page
Loading...
