Fagor CNC 8070 - Page 101

Operating manual
CNC 8070
MANUAL (JOG) MODE
5.
(REF: 1505)
·101·
Operations with the axes.
5.2.2 Jog
The axes may be jog using the JOG keyboard on the operator panel. The type of jog is
selected with the jog selector switch on the operator panel.
The jog keyboard and the feedrate selector
JOG keypad.
There are two types of jog keyboards depending on the behavior of the keys.
User keys as jog keys
The CNC offers the OEM the possibility to enable the user keys as jog keys. The user keys
defined this way behave like the jog keys.
Feedrate selector.
Continuous jog Incremental jog Handwheels
The keypad has two keys for each axis. One to jog the axis in the
positive direction and another one to move it in the negative direction.
To move a single axis, press the axis key and the one for its jogging
direction.
The keypad has a key for each axis and two keys for moving direction,
common to all the axes.
To jog an axis requires activating both the axis key and the moving
direction. There are two options, depending on how the jog keyboard
has been configured.
• The axis will move while both keys are pressed, the axis key and
the direction key.
• When pressing the axis key, the key remains active. The axis will
move while the direction key is kept pressed. To de-select the axis,
press [ESC] or [STOP].
The movement is carried out at the feedrate defined by the OEM. The
feedrate may be varied between 0% and 200% using the feedrate override
switch on the operator panel.
10000
1000
100
10
1
100
10
1
jog
jog
X+
X-
Y+ Z+
Y- Z-
7+ 7-
X
_
+
Y Z
4 5 6
200
190
180
170
160
150
140
130
120
110
100
90
80
70
60
50
40
30
20
10
4
2
0
FEE D