·258·
Operating manual
CNC 8070
16.
TOOL AND MAGAZINE TABLE
(REF: 1505)
Tool and tool magazine table.
Tool magazine
This information cannot be modified if the tool is in the spindle, on the changer arm or in the
magazine.
Size
Tool size. The size determines the number of positions (pockets) the tool occupies in the
magazine.
Positions to the right / Positions to the left
Space reserved in the magazine for the tool to the right and to the left of its position.
This data can be defined when the tool size is "custom".
Special
The tool always occupies the same position in the magazine.
Custom
Data defined by the manufacturer. On the setup panel of the tool table, it is possible to assign
a text to any of the 4 parameters.
Data 1 / Data 2
These data show, in numerical format, the information selected by the manufacturer.
Data 3 / Data 4
These data show, in binary format, the information selected by the manufacturer.
Comment
Comment associated with the tool.
Size Magazine positions it occupies.
Small It only occupies its position. It takes no extra position.
Medium It takes half of an additional position to the right and to the left.
Large It takes a full additional position to the right and to the left.
Custom The user defines the number of additional positions the tool occupies to its right
and to its left.
(A)Small tool.
(B)Average tool.
To Next Page
Loading...
