Operating manual
CNC 8070
TOOL AND MAGAZINE TABLE
16.
(REF: 1505)
·273·
Operations with the magazine table
Magazine management using the positions list.
This type of management is only valid for loading tools manually. It lets update the list of
positions after having placed the tools directly in the magazine, without using the CNC.
1 Select a magazine position from the list and enter the number of the tool it occupies it.
2 Press [ENTER] to update the positions list.
Unloading a tool
Magazine management using the "Unload tool" softkey.
This type of management is valid for unloading tools both automatically and manually. After
pressing the softkey, the user is asked what kind of loading to do.
1 Press the softkey associated with tool unloading.
2 Enter the number of the tool to be unloaded.
3 Press the [CYCLE START] key to unload the tool automatically to the spindle or the
[ENTER] key to update the positions list after unloading manually.
• Automatic unload (pressing [START]). The CNC unloads from the magazine a tool
defined in the table. It is unloaded to ground through the spindle.
• Manual loading (pressing [ENTER]). The CNC assumes that the tool defined in the table
has already been manually loaded from the magazine. It updates the magazine list.
Magazine management using the positions list.
This type of management is only valid for unloading tools manually. It lets update the list of
positions after having removed the tools directly from the magazine, without using the CNC.
1 Select a magazine position from the list and delete the number of the tool it occupies it.
2 Press [ENTER] to update the positions list.
The tool is unloaded into the magazine using the vertical softkey menu. After
unloading a tool from the magazine, it becomes a ground tool.
To Next Page
Loading...
