·368·
Operating manual
CNC 8070
20.
SETUP ASSISTANCE
(REF: 1505)
The circularity (roundness) test
Movement subroutine
The circular interpolation is carried out using a subroutine. See "20.3.5 Define and execute
the movement subroutine" on page 372.
The following data is taken into consideration when executing the subroutine.
• Plane where the circle is executed.
• Circle center coordinates.
• Circle radius.
• Programmed feedrate.
• Turning direction.
Parameters to be set
To make the adjustment, it is possible to change the CNC machine parameters or the drive
machine parameters involved. See "20.3.7 Adjustment of the machine parameters involved"
on page 374.
It is possible to interact with up to 11 different machine parameters. Some of these
parameters are always visible, but some may be defined at will. For each parameter, it shows
its value on each axis of the work plane.
To see the whole list of parameters that may be defined, see section "20.3.9 Machine
parameters that may be modified".
To Next Page
Loading...
