Fagor CNC 8070 - Page 385

Operating manual
CNC 8070
DDSSETUP
21.
(REF: 1505)
·385·
–Parameters and variables– service.
• Parameter units.
• Valid range of values. If the value is a string of characters, the field will show the maximum
length permitted.
• Name of the parameter.
Parameter editing.
Edit the new values directly in the value field or from the command line. If the parameter
accepts the new value, the table shows the change. The parameter table has a softkey to
reset the parameters to their default values.
For Sercos drives, the changes are saved in the RAM memory of the drive; to save the
changes permanently, use the softkey "Data" + "Flash" of the horizontal menu.
Horizontal softkey menu.
Operations with the parameter table.
Reset (initialize) and validate the parameter table.
The "Data" softkey of the horizontal menu offers the options to reset and validate the tables.
Save and load the parameters of the servo.
The "Data" softkey of the horizontal menu offers a series of options to make a backup copy
of the tables. The CNC saves the parameters of the device in a file whose name will be the
name of the axis or spindle and the extension lp (Sercos drives) or mlp (Mechatrolink servos).
Softkey. Function.
Print the parameter table.
This softkey prints the tables on a printer or into a file (extension prn). When
selecting the file option, it is saved, by default, in C:\Cnc8070\MTB\DATA.
Look for a parameter.
This softkey may be used to search for an element in the table using its
identifier.
Softkey. Function.
Save the servo parameters at the CNC.
This softkey resets the parameters of all the tables to their default values.
Restore the servo parameters from the CNC.
This softkey validates all the parameters of the servo.
In Mechatrolink devices, not all the parameters assume the new values immediately, sometimes, the
servo needs to be restarted so it assumes the new values. Refer to the documentation of the devices
to know when the servos assume the new values.
Softkey. Function.
Save the parameters at the CNC.
In a Sercos bus, this softkey saves in the CNC the parameters and variables
of the drive. In a Mechatrolink bus, this softkey saves in the CNC the
parameters of the servo.
Restore the parameters from the CNC.
In a Sercos bus, this softkey restores the parameters and variables of the
drive from the file saved in the CNC. The process of restoring the parameters
includes sending the command to save the parameters to flash.
In a Mechatrolink bus, this softkey restores the parameters of the servo from
the file saved in the CNC.