·46·
Operating manual
CNC 8070
2.
GENERAL CONCEPTS
(REF: 1505)
Work modes and software protection at the CNC.
User mode.
Part-programs must be saved in the "..\USERS" folder; the CNC considers the files saved
in other folders as temporary files and will be deleted when the CNC is turned off. Files from
flash, pendrives, ethernet, etc. can only be managed from the explorer of the utilities mode.
Protection level.
The user mode has the maximum protection level where only the folders and files that may
be changed during the normal operation of the machine are unprotected.
Protection password.
The access to this mode is not protected with the password.
Restrictions for working in Setup mode and switching to User
mode.
The purpose of the following restrictions is for the OEM to deliver his machines with the CNC
in protected work mode (User mode).
SETUP mode
On power-up, the CNC will show a message indicating that it is in an unprotected mode and
that the setup has not been completed yet. In this situation, the CNC is no longer under Fagor
warranty. After a certain period of time, with the next reset, the CNC shows the message
again.
When closing the application, the CNC asks if the setup is completed..
• If YES is selected and there are passwords, the CNC makes a backup copy and switches
over to USER mode (process OK).
• If YES is selected and there are no passwords, the CNC issues a warning message and
does not close the application.
USER mode (work mode).
On power-up, the CNC checks for passwords and a backup copy. If any of these two is
missing, the CNC will show a message indicating that setup has not been completed yet.
In this situation, the CNC is no longer under Fagor warranty. The CNC checks this at every
reset.
This situation can be reached when accessing the USER mode from SETUP mode through
"DiskMonitor".
It is the usual work mode for the user, once the setup is completed. This mode does not allow
updating the CNC or accessing the operative system. Some utilities of the operative system
(task manager, clock) will be available from the diagnosis mode.
To Next Page
Loading...
