·76·
Operating manual
CNC 8070
4.
AUTOMATIC MODE
(REF: 1505)
Program simulation and execution.
Find text
In this area of the dialog box, the CNC requests the text to look for. It is also possible to select
whether the search must start at the beginning of the program or at cursor position.
To start the search, press [ENTER] and the cursor will position on the text found. Pressing
[ENTER] again, the CNC will look for the next match and so on. To end the search, press
[ESC]. The cursor will position on the block containing the text searched.
To Next Page
Loading...
