Fagor CNC 8070 - Page 8

·8·
Operating manual
CNC 8070
(REF: 1505)
20.3 The circularity (roundness) test ................................................................................... 366
20.3.1 Interface description................................................................................................. 367
20.3.2 Softkey menus. ........................................................................................................ 369
20.3.3 Configuring and executing the circularity (roundness) test ...................................... 370
20.3.4 Configure the graphic environment.......................................................................... 371
20.3.5 Define and execute the movement subroutine ........................................................ 372
20.3.6 Data capture for the graphic .................................................................................... 373
20.3.7 Adjustment of the machine parameters involved ..................................................... 374
20.3.8 Validate the changes and save the configuration used ........................................... 376
20.3.9 Machine parameters that may be modified.............................................................. 377
CHAPTER 21 DDSSETUP
21.1 Appearance of the DDSSetup mode ........................................................................... 379
21.1.1 Icon description (vertical softkeys)........................................................................... 380
21.2 List of devices connected to the bus............................................................................ 381
21.3 Drives accessing level (only Sercos). .......................................................................... 383
21.4 –Parameters and variables– service. .......................................................................... 384
21.5 –Error management– service. ..................................................................................... 386
21.6 –Monitoring– service.................................................................................................... 387
21.7 –Information– service .................................................................................................. 389
21.8 Command generator (only Sercos). ............................................................................ 391
21.9 Command line.............................................................................................................. 392
21.10 File for setting the parameters of Mechatrolink servos. ............................................... 394
CHAPTER 22 DIAGNOSIS
22.1 Appearance of the diagnosis mode. ............................................................................ 397
22.1.1 Softkey menus. ........................................................................................................ 398
22.2 Configuration diagnosis ............................................................................................... 399
22.2.1 System diagnosis..................................................................................................... 399
22.2.2 Software diagnosis................................................................................................... 400
22.2.3 Hardware diagnosis. Bus CAN, Sercos and Mechatrolink....................................... 401
22.3 Sercos diagnosis ......................................................................................................... 403
22.4 Save the CAN configuration for the start-up test. ........................................................ 404
22.5 Report generation ........................................................................................................ 405
22.6 View the history of errors and warnings issued by the CNC........................................ 406
22.7 Generating the Fagor file for error diagnosis. .............................................................. 406
22.8 Access particular utilities of the operative system and other applications. .................. 406
CHAPTER 23 APPS
23.1 Send emails. ................................................................................................................408
23.1.1 Configure and activate the application..................................................................... 410
23.1.2 Configuring network properties. ............................................................................... 412