·82·
Operating manual
CNC 8070
4.
AUTOMATIC MODE
(REF: 1505)
Program simulation and execution.
• The simulation moves the axes of the machine. The axes move at the maximum feedrate
allowedregardless of the programmed "F" value. It is possible to change that feedrate
with the feedrate override switch.
• The simulation starts the spindle if it has been programmed.
• The simulation ignores the dwells programmed with G4.
• The simulation takes into account the program stops programmed with M00 and M01.
Rapid [S=0].
• The simulation ignores tool radius compensation (functions G41 and G42), hence
drawing the tool center path.
• The simulation sends M H S T functions to the PLC.
• The simulation moves the axes of the machine. The axes move at the maximum feedrate
allowedregardless of the programmed "F" value. It is possible to change that feedrate
with the feedrate override switch.
• The simulation does not start the spindle, except when the spindle works in closed loop
M19.
• The simulation ignores the dwells programmed with G4.
• The simulation takes into account the program stops programmed with M00 and M01.
To Next Page
Loading...
