·94·
Operating manual
CNC 8070
4.
AUTOMATIC MODE
(REF: 1505)
Block search.
8 Press [START] to execute the program.
Repositioning the axes.
Once the block search is finished, the CNC will show the axes that are out of position. The
axes may be repositioned individually or several at the same time in one of the following ways:
• Manually. Jog the axes with the handwheels or with the JOG keys. The movement is
limited by the repositioning end point and the corresponding software limit.
• Automatically. Select the axes with the relevant softkey and press [START]. Repositioning
may be interrupted (using the [STOP] key) to select other axes.
When an axis reaches the repositioning end point, it is no longer available; however, this axis
may be moved with the handwheel or the JOG keys under the same conditions as before.
Once all the axes have been repositioned, none of them may be moved.
Changing the machining conditions.
After positioning the axes and before resuming execution, tool inspection may be accessed
to change the machining conditions. In tool inspection, it is possible to change the feedrate
and the spindle speed, execute blocks in MDI/MDA mode as well as activate M and H
functions.
To Next Page
Loading...
