·98·
Operating manual
CNC 8070
5.
MANUAL (JOG) MODE
(REF: 1505)
Interface description.
D Tool related information. The information the CNC shows in this area depends on the
model, lathe or mill.
At a mill model, the screen shows the number of the active tool "T", the active tool offset
"D" for that tool and the number of the next tool "Nx Tool" and an icon representing the
type of tool. The CNC also shows the radius and length of the active tool.
At a lathe model, the screen shows the number of the active tool "T", the active tool offset
"D" for that tool and an icon representing the type of tool. The screen also shows the tool
offsets on each axis.
E Information related to the feedrate "F" of the axes:
"F real" Actual feedrate of the axes.
"F prog" Programmed feedrate.
"F%" Percentage of feedrate override being applied on to the programmed
value.
If the text "F real" appears in red, it means that the PLC is inhibiting the movement of
the axes (_FEEDHOL mark active). The status of the mark is not displayed if the screen
does not show this text.
F Information related to the spindle speed "S".
"S real" Actual spindle speed.
"S prog" Programmed speed.
"S%" Percentage of speed override being applied on to the programmed value.
Depending on the active screen, it will also show the spindle position "S pos" and its
following error "S fwe".
The screen only shows the data on one spindle. If there are several spindles in the
channel, the data on the next spindle may be displayed by pressing the "S" key twice (the
first time to program a turning speed).
If the text "S real" appears in red, it means that the PLC is inhibiting the movement of
the spindle (INHIBIT mark active). The status of the mark is not displayed if the screen
does not show this text.
G Moving mode selected at the jog selector switch on the operator panel.
H Reserved.
To Next Page
Loading...
