Updating the CopperPro with New Software
Step Three: Update the Tester’s Software
8
8-5
The Flash update occurs in blocks of flash data. The update begins with
the highest numbered block and works toward zero. The CopperPro
displays this progression as a series of “Processing block 0XX” messages.
The value XX represents the number of the block that is being transferred.
The number of the first block, however, is not determined until the Flash
update is created.
After Flash memory block 000 is finished processing (see Figure 8-2), the
CopperPro automatically powers down. The download process is
completed.
5. Disconnect the RS-232 cable from the PC and the tester.
You can now operate the CopperPro with the new version of software.
To Next Page
Loading...
