Fluke 990DSL - Page 57

Setting Up and Operating the CopperPro
Configuring the Tester
3
3-19
4. Press H to move the cursor to
Wire Center. Press A(Edit) and supply the
desired information. When you finish, press L.
Note
Wire Center defines the primary work location, such as a Central
Office Exchange, Cross-Connect Box, or Inside Terminal name. The
tester automatically includes the information that you supply for
Wire
Center in the header.
5. Press H to move the cursor to
Location. Press A(Edit) and supply the
desired information. When you finish, press L.
6. Press H to move the cursor to
Job Number. Press A(Edit) and supply
the desired information. When you finish, press L.
7. To include the information you supplied for the
Operator Name,
Location, and Job Number in the header for your result files, press
C(
Include All).
Note
If you do not press C(
Include All), the tester includes only the
information you supplied for
Wire Center and a timestamp.