Fuji Xerox Color 550

Common Service Settings
115
Tools
5
Paper Type Priority
Set the priority of the trays to use when paper of the same size and the same orientation is
set in the multiple trays for automatic tray selection.
Auto Paper selection means that a tray containing the appropriate paper is automatically
selected by the machine for copying or printing.
You can set plain paper, recycled paper, plain reload paper, and custom paper 1 to 5.
The paper type setting is prioritized over the paper tray priority settings.
If, however, different paper types appear in the same priority sequence, the paper is
determined by paper tray priority sequence. The tray containing paper type set to [Auto Paper
Off] is not selected by automatic tray selection.
For more information about the tray priority sequence, refer to "Paper Tray Priority" (P.114).
Tray 5 - Paper Size Defaults
Select the paper sizes displayed in the [Tray 5] screen in [Paper Supply] when copying with
Tray 5.
You can assign the paper size selected here to the buttons for [Standard Size] in the [Tray 5]
screen.
If you frequently use non-standard size paper for copying, assigning the paper sizes to the
buttons will save your time to specify the size each time. For your convenience, set the
commonly used paper sizes in the upper level.
A/B Series Size
You can select a paper size from A and B series sizes.
Inch Size
You can select a paper size from inch series sizes.
Others
You can select a paper size from other sizes.
Custom Size
You can enter any size. Set the X width between 148 and 488 mm, and the Y length between
100 and 330 mm in 1 mm increments.
Note • For open flap envelopes, enter the size with the flap size included.
Auto Tray Switching Control
Set the alternative tray or paper when the paper loaded in the tray selected runs out.
Auto Tray Switching
You can select from [Enable during Auto Select], and [Enable for Same Paper Type/Color].
Note • The machine does not switch the tray automatically in the following cases:
- Tray 5 is selected.
- The tray that is set as [Auto Paper Off] in [Paper Type Priority] is selected.
Targeted Paper Type (Copy Jobs)
You can select paper types.
When [According to Priority Assigned] is selected, the paper type is determined according to
the settings in [Paper Type Priority]. When selecting [Selected Paper Type Only], you can
specify the paper type.
Targeted Paper Color (Copy Jobs)
You can target all paper colors or only one paper color.
Note • The machine does not switch the tray automatically in the following cases:
- Tray 5 is selected.
- The tray that is set as [Auto Paper Off] in [Paper Type Priority] is selected.