Fuji Xerox Color 550

5 Tools
162
Tools
5
Failed Access Log
Set the failure count to detect unauthorized access. An error is logged if authentication fails
the number of times specified here within a predetermined time (10 minutes).
Logout Confirmation Screen
Set whether or not to display a logout confirmation screen every time a user session ends.
User ID for Login
Set whether or not to make the user ID entry field on the user login screen case-sensitive.
When you select [Case Sensitive], authentication is performed using the User ID as
registered (including upper and lower cases). When you select [Non-Case Sensitive],
authentication is performed with case ignored even if the User ID has both upper and lower
cases.
Maximum Login Attempts by System Administrator
This feature protects the settings from being changed by someone impersonating your
system administrator. If authentication for a system administrator’s ID fails more than
specified times continuously, access is denied.
You can specify a login attempt count from 1 to 10.
Note • The failure count is reset when the machine is restarted.
• To cancel the access rejection state, restart the machine by switching off and on the power.
Passcode Policy
Passcode Entry from Control Panel
You can set whether a passcode is required when the system administrator or a user uses
the machine. Selecting [On] enables [System Administrator’s Passcode] setting and
[Passcode] setting for [Create/View User Accounts].
Selecting [Off] does not require the passcode, even if a passcode is set in the above settings.
Important • The setting of [Passcode Entry from Control Panel] is used for authentication on the
machine. Depending on authentication procedures, a passcode may be required for other
processes as well.
Minimum Passcode Length
Set this item when you specify the minimum number of digits allowed for a passcode.
Set a value from 4 to 12 in 1 digit increments.
Note • This is only applicable to login users (not applicable to the system administrator and guests).
• Registered users can be authenticated with a passcode less than the minimum number of
digits.
Charge/Private Print Settings
This feature cannot be used on this machine.