GE MDS ORBIT ECR User Manual

120 MDS Orbit MCR/ECR Technical Manual MDS 05-6632A01, Rev. F
pki {
cert-id DevicePubCert;
key-id DevicePrivKey;
ca-cert-id CACert;
}
}
advanced-config {
lna-state high-sensitivity;
stale-packet-timeout 1500;
data-retries 3;
nic-id 0;
gateway-id 0;
arp-cache false;
adr-mode none;
adr-threshold -70;
encryption-protocol 2.0;
}
Other configuration
The advanced configuration on an NX915 module operating as a Remote, shares the same configuration
for LNA stat, stale packets timeout and data retries as an Access Point. The NIC and Gateway Identifier
are for use in manually configuring link paths a station will use in the network. The default value of 0 for
the identifiers configured the module to automatically obtain a path in the network. This is particularly
useful in a network that contains Store-and-Forward devices.
Store-and-Forward Mode
Basic configuration with defaults
The following will configure the NX915 module as a Store-and-Forward (SAF) device with the network
name of “MyNetwork” and default settings.
% set interfaces interface NxRadio nx-config device-mode store-and-forward network-name
MyNetwork
% show interfaces interface NxRadio nx-config | details
modem-mode 500kbps;
device-mode store-and-forward;
network-name MyNetwork;
data-compression none;
header-compression false;
power 30;
security {
security-mode none;
encryption none;
}
advanced-config {
lna-state high-sensitivity;
stale-packet-timeout 1500;
propagation-delay 40miles;
mcast-repeat 3;
data-retries 3;
fragment-threshold 0;
remote-age-time 600;
endpoint-age-time 300;

GE MDS ORBIT ECR Specifications

General

Brand	GE
Model	MDS ORBIT ECR
Category	Network Router
Language	English