MDS 05-6632A01, Rev. F MDS Orbit MCR/ECR Technical Manual 187
% set system dns server 192.168.1.2 search [mds gemds] options attempts 3 timeout 3
Monitoring
Ensure the CLI is in operational mode. Follow the example below to view the state and statistics.
The ping utility can be used on the CLI when it is in operational mode to verify that DNS is working
properly. If ping can resolve a name on the connected network to an IP address then DNS settings are
working properly. The example below shows the resolution of the name “example.com” to the IP address
“192.0.43.10” on a unit that is connected to the Internet.
Use the control sequence “CTRL-C” to stop the ping utility.
> ping example.com
PING example.com (192.0.43.10) 56(84) bytes of data.
64 bytes from 43-10.any.icann.org (192.0.43.10): icmp_req=1 ttl=128 time=184 ms
64 bytes from 43-10.any.icann.org (192.0.43.10): icmp_req=2 ttl=128 time=132 ms
64 bytes from 43-10.any.icann.org (192.0.43.10): icmp_req=3 ttl=128 time=172 ms
--- example ping statistics ---
3 packets transmitted, 3 received, 0% packet loss, time 2002ms
rtt min/avg/max/mdev = 132.818/163.231/184.739/22.112 ms
To Next Page
Loading...
