GE MDS ORBIT ECR - Page 229

MDS 05-6632A01, Rev. F MDS Orbit MCR/ECR Technical Manual 229
This menu displays a view of all rules created for the current rule set, as well as a means to create new
ones. The following options are available.
 Order – Click the arrows to sort rules in order of priority. Rules with higher priority are applied
before rules with lower priority; rule sets containing more than one rule should be sorted accordingly.
 Source IP – Apply rule to traffic that originates at a specific address or addresses.
 Mode – options:
- All – Apply rule regardless of source address.(The example above uses this
configuration.)
- Address - Apply rule to a specific source address and prefix.
- Address Range – Apply rule to a range of source addresses.
- Address Set – Apply rule to a non-contiguous set of source addresses.
- Not Address - Apply rule to traffic that does not originate from a specific address and
prefix.
- Not Address Range – Apply rule to traffic that does not originate from a specific source
address range.
- Not Address Set – Apply rule to traffic that does not originate within a non-contiguous
set of source addresses.
 Destination IP – Apply rule to traffic that ingresses the unit at a specific address or addresses.
 Mode – Options:
- All – Apply rule regardless of destination address. (The example above uses this
configuration.)
- Address - Apply rule to a specific destination address and prefix.
- Address Range – Apply rule to a range of destination addresses.
- Address Set – Apply rule to a non-contiguous set of destination addresses.
- Not Address - Apply rule to traffic that does not ingress at a specific address and prefix.
- Not Address Range – Apply rule to traffic that does not ingress at a specific destination
address range.
- Not Address Set – Apply rule to traffic that does not ingress at a non-contiguous set of
destination address
 Source NAT – Interface, Address.
- Interface – - Translate the source address to the address of the interface to which this
rule-set has been applied. (The example above uses this configuration).
- Address – Translate the source address to the specified address.