MDS 05-6632A01, Rev. F MDS Orbit MCR/ECR Technical Manual 289
Firmware Reprogram
Status – The current state of the firmware reprogramming process. This applies to both the
sending and receiving devices.
Peer Database (Sending device only) – During an active transfer, a table showing the IP
address and status of each participating receiving device will be displayed. If there is no
active transfer, the status of the last send operation will be shown for each device.
Using the CLI
To configure Remote Management, ensure that the CLI is in configuration mode.
Use the following command to enable the Remote Management service on the Bridge interface, with a
shared secret of rmadmin.
% set services remote-management enabled true interfaces Bridge shared-secret rmadmin
Use the following commands to enable the radio to send or receive firmware remotely, as well as manage
or be managed through a remote web UI session.
% set services remote-management firmware enabled true
% set services remote-management web-proxy-client enabled true
% set services remote-management web-proxy-server enabled true
You may perform remote management actions in either operational or configuration mode. The following
command requests remote units to reboot to image version 4.0.4.
% request services remote-management reboot-remote-devices interface Bridge which-image
{ version 4.0.4 }
The following command requests remote units to reboot to the active image version of the current radio.
For example, if the local radio’s active firmware image is version 4.0.0, remote radios will receive a
request to reboot to firmware version 4.0.0.
% request services remote-management reboot-remote-devices interface Bridge which-image
{ active }
The following command initiates a remote reprogramming session of the current radio’s active image
over the Bridge interface, with a blocksize of 512, at a rate of 500 kbps. Remotes are requested to reboot
to the new image upon successful completion.
% request services remote-management send-local-firmware blocksize 512 interface Bridge
reboot-remotes-on-completion true txrate 500 which-image { active }
Use the following command to cancel the currently active remote reprogramming or management session.
% request services remote-management cancel-session
Monitoring
To view the current Remote Management status, ensure that the CLI is in operational mode.
% show services remote-management-status
services remote-management-status web-proxy-client status disabled
services remote-management status web-proxy-server status operating
To Next Page
Loading...
