312 MDS Orbit MCR/ECR Technical Manual MDS 05-6632A01, Rev. F
Assign a security model to User1 by clicking on the “User1” in the Sec Name table. 6.
Sec Model - The security models under which this security Name (i.e. USM) is a member of this
group.
Next, assign the “internet” SNMP view as the Read View of the “usm” Access Sec Model. 7.
Read View - The name of the MIB view of the SNMP context authorizing read access.
Write View - The name of the MIB view of the SNMP context authorizing write access.
Notify View - The name of the MIB view of the SNMP context authorizing notify access.
Filling in the VACM Group parameter values can be accomplished via the CLI using the following 8.
commands:
% set services snmp vacm group secure member User1 sec-model [usm]
% set services snmp vacm group secure access usm auth-priv read-view internet
Commit configuration 9.
To Next Page
Loading...
