338 MDS Orbit MCR/ECR Technical Manual MDS 05-6632A01, Rev. F
Add BOND interface to the Bridge
Add the Bond1 tunnel interface to the bridge that has NX interface and disable STP on the bridge. 1.
Please refer to section on Bridging for help with adding members to a bridge.
Configure NETMON operation
Configure a NETMON service icmp-echo-monitor operation named NX-LINK-CHECK that does 1.
a periodic link check by pinging AP. This is needed to generate a periodic traffic towards AP to
enable the latter to update its bridge forwarding table when the REMOTE switches its link from NX
to/from GRE tunnel. The time interval of this traffic determines the time interval of failover at the
AP. Please refer NETMON service section for help with configuration.
To Next Page
Loading...
