GE Voluson E6

GE HEALTHCARE VOLUSON E8 / VOLUSON E6
D
IRECTION KTD102576, REVISION 7 SERVICE MANUAL
II Index
External USB-Devices, 3-30
Doppler Mode Checks
Functional Checks, 4-16
DVD Recorder Settings
Adjustment, 3-18
E
ECG
Functional Checks, 4-46
Theory, 5-59
Electrical Requirements, 2-2
Electrical Safety, 1-12
Electrostatic Discharge Warning, 1-16
EMC
Electromagnetic Compatibility, 1-16
EMI Protection, 3-8
Erasing DVD/CD, 4-31
Error Messages, 7-32
Export Log´s and System Data, 7-10
External I/O
Theory, 5-58
External USB-Devices
Disconnection, 3-30
F
FMI from DVD
Installation Procedure, 8-6
Theory, 5-73
Footrest Cover
Replacement Procedure, 8-16
FrontEnd
RFI - Radio Frequ. Interface "Controller" Board, 5-30
RSR - Beamformer Receiver Subboard, 5-28
RST - Beamformer Transmitter Subboard, 5-28
RSW - CW Doppler Board, 5-29
RTF - Probe Connector Board, 5-25
RTK - Motherboard, 5-29
RTM - Beamformer Board, 5-27
Full Backup (Full System Configuration)
Loading Procedure, 8-12
Full System Configuration (Full Backup)
Delete, 4-41
Load, 4-39
Save, 4-37
Functional Checks, 4-1
2D Mode, 4-9
Additional Operating Modes, 4-12
Brakes, 4-47
Calculation Measurements, 4-28
Cine Mode, 4-23
Color Flow Modes, 4-17
Control Panel, 4-5
Doppler Modes, 4-16
ECG Checkout, 4-46
Generic Measurements, 4-25
M Mode, 4-14
Mechanical, 4-47
Monitor Display, 4-7
Peripherals, 4-46
Probes/Connector Usage, 4-29
Required Equipment, 4-1
Touch Panel, 4-6
Volume Modes, 4-19
Fuses of Primary Power Module (RTN), 5-61
G
General Cleaning, 10-9
Generic Measurements
Functional Checks, 4-25
H
Hard Disk Drive, 5-33
Hardware Configuration Detection, 7-4
Hardware Options, 5-22
Hazard Icons, 1-8
How to check power, 7-8
How to check status of the Diagnostic LED´s, 7-8
How to configure the Service Platform, 7-15
How to enable/disable Disruptive Mode and VCO, 5-66, ,
7-12
How to identify the Systems, 1-6
How to lift the console without booting the system, 6-8
How to lift/move the System, 3-2
How to lower the console without booting the system, 6-8
How to readjust Monitor Settings, 6-2
How to remove the Trackball (for cleaning purpose), 7-24
How to use the Auto Tester, 7-16
Human Safety, 1-11
I
Image Archive
Load, 4-44
Loading Procedure, 8-12
Save, 4-42
Image Settings Only
Loading Procedure, 8-12
Inrush Current, 2-3
Installation
Digital Black & White Printer, 3-36
Digital Color Printer, 3-36
System Software, 8-3
System Software (FMI from DVD), 8-6
Internal I/O
Theory, 5-37