H3C S3100 Series User Manual

1-19
To do… Use the command… Remarks
Configure the IP address of the
DNS server
dns-server
ip-address
Required
By default, no DNS server address
is configured.
Start the test
test-enable
Required
Display test results
display hwping results
[ admin-name operation-tag ]
Required
The
display
command can be
executed in any view.
10) Clear all agents on the HWPing client
Follow these steps to clear all agents on the HWPing client:
To do… Use the command… Remarks
Enter system view
system-view
—
Clear all agents on the HWPing
client
hwping-agent clear
Required
z This command clears all the configured agents, including the test configuration, test result, and
history information.
z The result cannot be restored after the execution of the command.
z The command does not disable HWPing-agent.
Configuring HWPing client to send Trap messages
Trap messages are generated regardless of whether the HWPing test succeeds or fails. You can
specify whether to output Trap messages by enabling/disabling Trap sending.
Follow these steps to configure the HWPing client to send Trap messages:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the HWPing client function
hwping-agent enable
Required
By default, the HWPing client
function is disabled.
Create an HWPing test group and
enter its view
hwping
administrator-name
operation- tag
Required
By default, no test group is
configured.
Enable the HWPing client to send
Trap messages
send-trap
{
all
| {
probefailure
|
testcomplete
|
testfailure
}
* }
Required
By default, Trap sending is
disabled.
Configure the number of
consecutive unsuccessful HWPing
tests before Trap output
test-failtimes
times
Optional
By default, Trap messages are
sent each time a test fails.
Configure the number of
consecutive unsuccessful HWPing
probes before Trap output
probe-failtimes
times
Optional
By default, Trap messages are
sent each time a probe fails.

H3C S3100 Series Specifications

General

Brand	H3C
Model	S3100 Series
Category	Switch
Language	English