Configuration for contact Probe
Once Metrolog is installed, run Metrolog configuration program (in case it doesn’t start automatically, go to:
Start Menu > All Programs > Metrolog > Configuration Assistant).
1. Enter user name and password then Next
2. Skip following window by “Next”
3. On next window, select “type of machine”: “Absolute RDS” and check “Automatically recall last probes
file” then click on “Next”.
4. Finish the configuration by clicking on “Save”
5. Run Metrolog software, the probe is automatically recognized and activated, and the system is ready
to use.
To Next Page
Loading...
