Hexagon RDS - Probe List and Selection

RDS Control Panel
H000002007-RDS User Manual │Version 5.0.0 (2018-09-17) │58
D.6.1 PROBE LIST AND SELECTION
By default, the probe is automatically recognized and selected when plugged on the arm.
It is possible to deactivate and select manually the probe.
NAME
TYPE
STATUS
DIAMETER
RESULT
Centre reference probe
Hard probe
15.000
0.000000
Ball 6mm
Hard probe
Detected
6.000
0.000755
Ball 3mm
Hard probe
3.000
0.003585
NCP2
Tube probe
0.086
0.086842
HP-L-8.9 15-03-016
RSx
0.000
0.000393
In the sheet above, are shown all available probes, with all corresponding information.
Information
Description
Displayed value
Name
Name of the probe entered when Aligned
name
Type
Show the type of probe (contact, trigger, scanner,
Tube probe)
type
Status
Current status (null / Detected / Forced)
status
Diameter
Diameter of the ball probe
Diameter in selected unit
Calculation
result
Result of the last Alignment of the selected probe
= “Not Aligned” when probe is not
Aligned