RDS Control Panel
H000002007-RDS User Manual │Version 5.0.0 (2018-09-17) │77
Type of Reference:
• Permanent: a reference can be memorized in the arm memory, to be able to use it even after a restart
of the system: this can be necessary if the work is not finished and has to be continued after a restart.
• Temporary: (default for Leap-Frog) the reference is not memorized in the arm memory, but simply
temporary on the computer, until the arm is restarted. Then the reference is lost. In case there could
be a necessity to stop the work and restart the system, then it is recommended to define this reference
as a permanent, to save it, and when the work is finished, to delete it
All references notified as “Permanent” are saved in the arm memory: if the arm is connected
on another computer, it is not necessary to reload those references.
Use to add a reference from a file, or
to add a configuration file for LOK
To Next Page
Loading...
