Hioki 3174 - Page 169

9.4 Message Reference
163
99
Queries the measured current value for withstand-voltage tests
Syntax
(Query)
:MEASure:WITHstand:CURRent?
Queries the measured current value (unit: mA) for withstand-voltage
tests.
(Response)
<Measured current value for withstand-voltage tests (NR2)>
Example
(Query)
:MEASure:WITHstand:CURRent?
(Response)
2.00
The measured current value is 2.00 mA.
Error
The execution of this command in a state other than the TEST state causes an
execution error.
Queries the test time elapsed for withstand-voltage tests
Syntax
(Query)
:MEASure:WITHstand:TIMer?
Queries the test time elapsed (unit: s) for withstand-voltage tests.
(Response)
<Withstand-voltage test time elapsed>, <Types of timers>
Withstand-voltage test time elapsed (NR2, unit: s)
Types of timers ...............0/ 1/ 2 (NR1)
0: test time
1: ramp-up time
2: ramp-down time
Example
(Query)
:MEASure:WITHstand:TIMer?
(Response)
30.0,0
The elapsed test time is 30.0 s, and the type of timer is test time.
Error
The execution of this command in a state other than the TEST state causes an
execution error.