C300 Controller start up
C300 Controller states in boot mode
160 Experion C300 Controller User's Guide R301.1
Honeywell 11/06
Figure 6 C300 Controller Startup and Boot Mode indications
C300 Controller states in boot mode
At the conclusion of POST, it determines whether or not there is a valid Application
Image present in the controller and whether it should then transition to executing this
Application image (Application mode) or to continue in the Boot mode.
• If the controller remains in the Boot mode, the controller then enters one of the states
in Table 6 and joins the FTE network on which it resides. See Table 12 for a
description of the faceplate indications when the controller is operating in the boot
mode.
• If the controller transitions to the Application mode, the controller then joins the
FTE network and enters one of the operating states described in Table 7.
Table 6 Controller in Boot mode
Controller
State
Description
ALIVE
The controller determines that no application image exists or an
To Next Page
Loading...
