Using Station displays
C300 Controller Point Detail displays
180 Experion C300 Controller User's Guide R301.1
Honeywell 11/06
Step Action
6
Click the OK button to close the Parameters form.
7
This completes the procedure.
Using Station displays
Operation and status information as well as statistics for C300 Controllers can be
monitored through various displays located on Experion servers and stations. Some of
these displays are briefly described below. See the Operator’s Guide for more
information about system and detail displays in Station.
C300 Controller Point Detail displays
The Experion server Station application includes pre-configured Detail displays for the
C300 Controller and function blocks. These displays are the default entries for the Point
Detail Display parameter on the Server Displays tab of the configuration form.
Once you establish communications with a C300 Controller you can begin monitoring
the status of any component that has been loaded as part of a control strategy to a C300
Controller with points registered in the Experion server. The Detail displays let you
quickly view the component’s current state, fault status and pertinent configuration data.
Controller Detail displays
The Controller Status display provides a status of each controller and its type. Click on
the Controller name to call up the Controller’s Detail display. This display shows
operating values and error statistics that indicate the ‘health’ of the controller.
Event and Alarm summary displays
Experion Station also provides Event and Alarm Summary displays that support C300
Controller notifications and events. These displays are integrated with Experion
component data. Use the Event Summary to get a quick view of recent actions that have
taken place within the system.
FTE Status display
The C300 Controller is a single node on the FTE network. As one of the System Status
displays in Station, the FTE Status display provides status information for each node on
the associated network.
To Next Page
Loading...
