Copy Control Modules
To copy an existing Control Module
R301.1 Experion C300 Controller User's Guide 67
11/06 Honeywell
Step Action Result
3
Change the Control Module block’s
Tagname in the Destination column of
the Name New Function Block(s) dialog
to a desired name or accept the default
name.
The copied Control Module block is
assigned a new name.
Note: You may opt to keep the
default name which is simply the
original name with a number
appended to it.
4
Click Next to proceed to the next dialog
page (if appropriate) and enter new
names as prompted to resolve any
existing connections and/or
associations.
If the CM contains connections to
outside blocks, an additional dialog
page appears which is used to
resolve any existing connections
and/or associations.
5
Click Finish
Copied Control Module block with
newly-designated name is pasted
onto the Project Tree.
To Next Page
Loading...
