34
Condition: This symptom occurs if the OpenFlow controller uses BDDP to perform topology
discovery.
201509160400
Symptom: A user line cannot be configured by using the line number command.
Condition: This symptom occurs if you use the line number command to configure the user line.
201509180141
Symptom: In CWMP, a CPE fails to establish a connection to a server.
Condition: This symptom occurs if the CWMP connection interface belongs to a VPN instance.
201511040399
Symptom: The expected bandwidth configuration on a VLAN interface is lost.
Condition: This symptom occurs after two master/subordinate switchovers.
201512010078
Symptom: The boot-loader file command fails to specify a startup image file.
Condition: This symptom occurs if the startup image file resides on the standby MPU.
201510300441
Symptom: Unexpected page break occurs during faxing or fax negotiation fails.
Condition: This symptom occurs if multiple voice calls are established during faxing.
201512110328
Symptom: MAC address entries age out when they are configured not to age.
Condition: None.
201510160271
Symptom: The dual-stack PPPoE server that mainly provides IPv6 services exhausts IPv6
addresses in the DHCPv6 address pool. PPPoE users who have no IPv6 addresses assigned
can log in.
Condition: This symptom occurs if two master/subordinate switchovers occur after IPv6
address exhaustion.
201510220524
Symptom: A logged-in PPPoE user cannot receive traffic.
Condition: This symptom occurs if the following conditions exist:
Two routers form an IRF fabric.
The PPPoE user logs in through an IRF port.
The master device reboots.
201510130373
Symptom: A SIP call cannot be established.
Condition: This symptom occurs if the router receives an INVITE request without SDP
information.
201507200041
Symptom: The VE1 PRI Layer 3 test fails.
Condition: This symptom occurs if the device receives a SETUP message in which the value of
the cap. field is video.
To Next Page