EasyManua.ls Logo

HPE MSR3000 - Page 39

HPE MSR3000
371 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
35
201510160206
Symptom: The dual-stack PPPoE server that mainly provides IPv6 services has available IPv6
addresses in the DHCPv6 address pool. PPPoE users who have no IPv4 addresses assigned
cannot log in.
Condition: None.
201509220301
Symptom: The Cellular process reboots unexpectedly.
Condition: This symptom occurs if the profile main command is executed on a cellular
interface on the MSR4000.
201510230327
Symptom: If a PPPoE user logs in and then logs out, the CIR specified in the user profile for the
user does not take effect.
Condition: This symptom occurs if the following conditions exist:
Two routers form an IRF fabric.
The PPPoE user logs in through an IRF port.
The master device reboots.
201508100249
Symptom: No information is displayed after the display voice sip call command is executed
on the MSR4000.
Condition: None.
201512180019
Symptom: The AC of an MPLS L2VPN cannot receive packets from a CE.
Condition: This symptom occurs if a Layer 3 aggregate subinterface is used as the AC of the
MPLS L2VPN.
201511250428
Symptom: Settings of the answer-time, idle-time, and trade-time parameters cannot be
deployed to interface cards related to POS terminal access.
Condition: This symptom occurs if you set the answer-time, idle-time, and trade-time
parameters in system view.
201512010169
Symptom: An error occurs on an IRF physical interface after the router reboots and some
operations are performed on the router.
Condition: This symptom occurs if two GigabitEthernet interfaces are used as IRF physical
interfaces and one of the IRF physical interfaces goes down.
201512030468
Symptom: Packet filtering does not take effect on an Ethernet interface operating in bridge
mode.
Condition: This symptom occurs if packet filtering is enabled on the Ethernet interface operating
in bridge mode.
201511210055
Symptom: Interfaces on the HMIM-8GSW or HMIM-24GSW interface card receive a large
number of ARP requests. Then, a packet statistics error occurs and the switching modules
cannot operate correctly.

Table of Contents

Related product manuals