v Does not use authentication keys
v Library polling is every 12 hours
To modify the date and time settings:
1. In the Configure Library menu in the left navigation pane of the Web User Interface, click Date and
Time.
2. Select the Date and Time settings.
v Select the Enable NTP Server check box to enable time and date control with a time server on the
network.
– NTP server address - Enter the IP address of the time server. IPv4 and IPv6 addresses are
supported, depending on the TCP/IP settings. Host names can be entered instead of numerical
IP addresses if Use DNS is selected in the Network settings.
– Time zone - Enter the time zone relative to Coordinated Universal Time (UTC).
v If the time server is disabled, enter the local time and date manually.
– Date - Enter the date with the MM/DD/YYYY format.
– Time - Enter the time with the HH:MM:SS format.
v Click Load PC date time to synchronize the library with the clock on your host computer at regular
intervals.
3. Click Submit to update the settings.
Installation and configuration 43
|
|
|
|
|
|
|
To Next Page
Loading...
Need help?
General